Dlp-B262 Filter The Display Of Circuits - Cisco ONS 15327 Procedure Manual

NTP-B199 Locate and View Circuits
As needed, complete the
Step 2
As needed, complete the
Step 3
As needed, complete the
Step 4
Stop. You have completed this procedure.

DLP-B262 Filter the Display of Circuits

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Navigate to the appropriate CTC view:
Step 1
•
•
•
Click the Circuits tab.
Step 2
Set the attributes for filtering the circuit display:
Step 3
a.
b.
Cisco ONS 15327 Procedure Guide, R4.0
8-4
"DLP-B131 Search for Circuits" task on page
"DLP-B262 Filter the Display of Circuits" task on page
"DLP-B229 View Circuits on a Span" task on page
This task filters the display of circuits in the ONS 15327 network, node, or
card view Circuits window based on circuit name, size, type, direction, and
other attributes.
None
DLP-B60 Log into CTC, page 2-23
As needed
Onsite or remote
Retrieve or higher
To filter network circuits, from the View menu choose Go to Network View.
To filter circuits that originate, terminate, or pass through a specific node, from the View menu.
choose Go to Other Node, then choose the node you want to search and click OK.
To filter circuits that originate, terminate, or pass through a specific card, double-click the card on
the shelf graphic in node view to display the card in card view.
Click the Filter button.
On the Filter Dialog, set the filter attributes:
– Name—Enter a complete or partial circuit name to filter circuits based on circuit name;
otherwise leave the field blank.
– Direction—Choose one: Any (direction not used to filter circuits), 1-way (display only one-way
circuits), or 2-way (display only two-way circuits).
– Status—Choose one: Any (status not used to filter circuits), Active (display only active
circuits), Incomplete (display only incomplete circuits, that is, circuits missing a connection or
span to form a complete path), or Upgradable (display only upgradable circuits, that is, circuits
created in TL1 that are ready to upgrade in CTC). See
circuit statuses. Although other statuses are described in
for Active, Incomplete, and Upgradable circuits.
State—Choose one: OOS (display only out-of-service circuits), IS (display only inservice
–
circuits), OOS-AINS (display only out of service, auto inservice circuits), or OOS-MT (display
only out of service, maintenance circuits.) See
states.
Chapter 8
8-5.
8-6.
Table 8-1 for more information about
Table 8-1, filtering is only supported
Table 8-2 for more information about circuit
Manage Circuits
8-4.
March 2003