Ntp-B32 Provision External Alarms And Controls On The Xtc - Cisco ONS 15327 Procedure Manual

Chapter 6 Manage Alarms

NTP-B32 Provision External Alarms and Controls on the XTC

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
For information about the XTC external alarms and controls, virtual wire and orderwire, refer to the
Note
Cisco ONS 15327 Reference Guide.
External alarm physical connections are made on the MIC. However, the alarms are provisioned using
Note
the XTC card view.
In the node view, double-click the active XTC card. The card view appears.
Step 1
If you are provisioning external alarms, click the Provisioning > External Alarms tabs
Step 2
If you are not provisioning external alarms, continue with
Note
November 2004
Use this procedure to create external (environmental) alarms and external
controls.
An XTC card must be installed in Slot 5 or 6.
NTP-B24 Verify Card Installation, page 3-2
As needed
Onsite or remote
Provisioning or higher
You can only provision external alarms on the active XTC card.
NTP-B32 Provision External Alarms and Controls on the XTC
Step 6.
Cisco ONS 15327 Procedure Guide, R4.0
(Figure 6-16).
6-33