Cisco ONS 15327 Procedure Manual page 233

Chapter 5 Create Circuits and VT Tunnels
VLANs
•
ONS 15327 nodes
•
If the information is not correct, click the Back button and repeat the procedure with the correct
information.
Click Finish.
Step 18
Complete the
Step 19
Complete the
Step 20
Step 21 From the View menu choose Go to Home View.
Step 22 Click the Circuits tab.
Highlight the circuit and click Edit.
Step 23
The Edit Circuit dialog box opens.
Click Drops and click Create.
Step 24
The Define New Drop dialog box opens.
From the Slot menu choose the OC-N card that links the ONS 15327 to the non-ONS 15327 equipment.
Step 25
From the Port menu choose the appropriate port.
Step 26
Step 27 From the STS menu choose the STS that matches the STS of the connecting non-ONS equipment.
Step 28 Click OK.
Step 29 Confirm the circuit information that displays in the Edit Circuit dialog box and click Close.
Repeat Steps
Step 30
The first and second Ethernet manual cross-connects will be bridged by the OC-N STS.
The appropriate STS circuit must exist in the non-ONS equipment to connect the two Ethernet manual
Note
cross-connect endpoints.
If a CARLOSS alarm repeatedly appears and clears on an Ethernet manual cross-connect, the two
Caution
Ethernet circuits might have a circuit-size mismatch. For example, a circuit size of STS-3c was
configured on the first ONS 15327 and circuit size of STS-1 was configured on the second ONS 15327.
Refer to the Cisco ONS 15327 Troubleshooting Guide if the alarm persists.
Complete the
Step 31
Stop. You have completed this procedure.
March 2003
"DLP-B220 Provision E-Series Ethernet Ports" task on page
"DLP-B221 Provision E-Series Ethernet Ports for VLAN Membership" task on page
2 through 29 at the second Ethernet manual cross-connect endpoint.
"NTP-B146 Test E-Series Circuits" task on page
NTP-B145 Create an E-Series Multicard EtherSwitch Manual Cross-Connect
5-72.
Cisco ONS 15327 Procedure Guide, R4.0
5-69.
5-70.
5-67