Ntp-B46 Subtend A Path Protection From A Blsr; Figure 4-6 Integrated Path Protection Dri Example - Cisco ONS 15327 Procedure Manual

NTP-B46 Subtend a Path Protection from a BLSR

Figure 4-6
Stop. You have completed this procedure.
NTP-B46 Subtend a Path Protection from a BLSR
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In the node that will subtend the path protection (Node 3 in
Step 1
cards that will serve as the path protection trunk (span) cards (Node 3, Slots 3 and 4). See the
Install the Optical and Ethernet Cards" procedure on page
Step
Cisco ONS 15327 Procedure Guide, R4.0
4-30
Integrated Path Protection DRI Example
Tx Rx
Slot 3
Tx Rx
Slot 1
Node 1
Tx Rx
Slot 4
Tx Rx
Slot 3
Tx Rx
Slot 2
Tx Rx
Slot 1
Node 3
Tx Rx
Slot 3
Tx Rx
Slot 1
Node 5
This procedure subtends a path protection from an existing BLSR.
One BLSR node must have OC-N cards and fibers to carry the path
protection.
NTP-B175 BLSR Acceptance Test, page 4-17
As needed
Onsite
Provisioning or higher
2.
Chapter 4
Tx Rx
Slot 3
Tx Rx
Slot 1
Node 2
Tx Rx
Slot 4
Tx Rx
Slot 3
Tx Rx
Slot 2
Tx Rx
Slot 1
Node 4
Tx Rx
Slot 3
Tx Rx
Slot 1
Node 6
Figure 4-7), install the two (east/west) OC-N
1-23. If they are already installed, go to
Turn Up Network
"NTP-B218
March 2003