Dlp-B221 Provision E-Series Ethernet Ports For Vlan Membership - Cisco ONS 15327 Procedure Manual
Hide thumbs
Also See for ONS 15327:
- User documentation (559 pages) ,
- Manual (42 pages) ,
- Reference manual (166 pages)
Table of Contents
Advertisement
NTP-B145 Create an E-Series Multicard EtherSwitch Manual Cross-Connect
For each Ethernet port, provision the following parameters:
Step 4
•
•
•
•
•
Click Apply.
Step 5
Repeat Steps
Step 6
point-to-point circuit.
The Ethernet ports are provisioned and ready to be configured for VLAN membership. See the
Step 7
"DLP-B221 Provision E-Series Ethernet Ports for VLAN Membership" task on page 5-70
instructions.
Step 8
Return to your originating procedure (NTP).
DLP-B221 Provision E-Series Ethernet Ports for VLAN Membership
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1
Display the node view.
Step 2
Double-click the E-Series card graphic to open the card.
Click the Provisioning > Ether VLAN tabs.
Step 3
To put a port in a VLAN:
Step 4
a.
Cisco ONS 15327 Procedure Guide, R4.0
5-70
Port Name—If you want to label the port, type a port name.
Mode—Choose the appropriate mode for the Ethernet port: Valid choices for the E-Series card are
Auto, 10 Half, 10 Full, 100 Half, or 100 Full.
Enabled—Check this check box to activate the corresponding Ethernet port.
Priority—Choose a queuing priority for the port. Options range from 0 (Low) to 7 (High). Priority
queuing (IEEE 802.1Q) reduces the impact of network congestion by mapping Ethernet traffic to
different priority levels. Refer to the priority queuing information in the Cisco ONS 15327 Reference
Manual. This parameter does not apply to an E-Series card in port-mapped mode.
Stp Enabled—Check this check box to enable the spanning tree protocol (STP) on the port. This
parameter does not apply to an E-Series card in port-mapped mode. Refer to the spanning tree
information in the Cisco ONS 15327 Reference Manual.
1
through
5
for all other cards in the VLAN or in port-mapped mode, the other card in a
This task provisions E-Series card ports for VLAN membership. It does not
apply to E-Series cards in port-mapped mode.
None
DLP-B60 Log into CTC, page 2-23
As needed
Onsite or remote
Provisioning or higher
Click the port and choose either Tagged or Untag.
Chapter 5
Create Circuits and VT Tunnels
Table 5-4
shows valid port settings.
for
March 2003
Advertisement
Table of Contents
