Cisco ONS 15327 Procedure Manual page 475

Appendix D Alternate Installation Procedures
Connect the office power according to the fuse panel engineering specifications.
Step 1
Measure and cut the cables as needed to reach the ONS 15327 from the fuse panel.
Step 2
Dress the power according to local site practice.
Step 3
When installing the ONS 15327, the ground connection must always be made first and disconnected
Warning
last.
Strip .22 inches of insulation from all power cables that you connect to the ONS 15327 power
Step 4
connectors.
Do not expose more than .22 inches of bare wire on power cables.
Warning
Before you make any crimp connections, coat all bare conductors (battery, battery return, and frame
Caution
ground) with an appropriate antioxidant compound. Bring all unplated connectors, braided strap, and bus
bars to a bright finish, then coat with an antioxidant before you connect them. You do not need to prepare
tinned, solder-plated, or silver-plated connectors and other plated connection surfaces in this manner, but
always keep them clean and free of contaminants.
Note
If the power connector is already installed, remove it from the MIC by grasping it with your fingers and
Step 5
gently pulling it. If you cannot remove it easily, you can use a pair of needle nose pliers and grab it by
the center of the channel.
Crimp the terminal lugs to the power cables.
Step 6
Remove the terminal lug screws and discard.
Step 7
Insert the return (black) power cable in the right hand (RET) slot of the connector.
Step 8
proper orientation of the terminal lugs.
Warning Make sure the flat part of the lug faces away from the center of the connector.
March 2003
NTP-B222 Connect Office Power to the ONS 15327 Shelf (Terminal-Lug Power Connector)
To install the terminal-lug power connector, see the
ONS 15327 Shelf (Terminal-Lug Power Connector)" procedure on page
"NTP-B222 Connect Office Power to the
D-4.
Figure D-3
Cisco ONS 15327 Procedure Guide, R4.0
show the
D-5