Ntp-B47 Subtend A Blsr From A Path Protection; Ntp-B48 Subtend A Blsr From A Blsr - Cisco ONS 15327 Procedure Manual
Hide thumbs
Also See for ONS 15327:
- User documentation (559 pages) ,
- Manual (42 pages) ,
- Reference manual (166 pages)
Table of Contents
Advertisement
NTP-B47 Subtend a BLSR from a Path Protection
NTP-B47 Subtend a BLSR from a Path Protection
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In the path protection node that will subtend the BLSR, install the two (east and west) OC-N cards that
Step 1
will serve as the BLSR trunk (span) cards (in
"NTP-B218 Install the Optical and Ethernet Cards" procedure on page
Step 2
Attach fibers from the cards in
Figure 4-7 on page
1/Node 1.
Log into the ONS 15327 that will subtend the BLSR (the node in Step 1). See the
Step 3
CTC" task on page 2-23
Create the DCCs on both OC-N trunk cards (east and west) that will carry the BLSR. See the
Step 4
Provision SONET DCC Terminations" task on page 4-5
Create the subtending BLSR:
Step 5
a.
b.
From the View menu choose Go to the Network View to see the subtending ring.
Step 6
Stop. You have completed this procedure.
NTP-B48 Subtend a BLSR from a BLSR
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Cisco ONS 15327 Procedure Guide, R4.0
4-32
This procedure subtends a BLSR from an existing path protection.
One path protection node must have OC-N cards and fibers to carry the
BLSR.
NTP-B177 Path Protection Acceptance Test, page 4-24
As needed
Onsite
Provisioning or higher
4-31, Slot 1/Node 3 connects to Slot 2/Node 2, and Slot 2/Node 3 connects to Slot
for instructions. If you are already logged in, continue with Step 4.
Complete the
"NTP-B40 Provision BLSR Nodes" procedure on page 4-14
in the BLSR. If you have already provisioned the BLSR, perform this procedure for the subtending
node only.
Complete the
"NTP-B126 Create a BLSR" procedure on page
node that will subtend the BLSR) in the BLSR.
This procedure subtends a BLSR from an existing BLSR.
One BLSR node must have OC-N cards and fibers needed to carry the
second BLSR.
As needed
Onsite
Provisioning or higher
Figure 4-7 on page
Step 1
to the BLSR trunk cards on another BLSR node or nodes. In
for instructions.
Chapter 4
Turn Up Network
4-31, Node 3, Slots 1 and 2). See the
1-23.
"DLP-B60 Log into
"DLP-B253
for each node that will be
4-15. Include the node in
Step 3
(the
March 2003
Advertisement
Table of Contents
