Dlp-B324 Install Ds-1 Champ Cables On A Mic - Cisco ONS 15327 Procedure Manual

NTP-B220 Install the Electrical Cables

DLP-B324 Install DS-1 Champ Cables on a MIC

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Always use the supplied ESD wristband when working with a powered ONS 15327. Plug the wristband
Caution
cable into the ESD jack located between the top high-speed and XTC slots.
Step 1 Prepare a 56-wire cable for each DS-1 connection you will make. See
Champ connector pin assignments.
Table 1-5
Signal/Wire
Tx Tip 1
white/blue
Tx Tip 2
white/orange
Tx Tip 3
white/green
Tx Tip 4
white/brown
Cisco ONS 15327 Procedure Guide, R4.0
1-34
This task installs DS-1 cables.
One of the following DS-1 cables (either right-angle or straight):
Right-angle DS-1 cable
•
– Amphenol GCA70 03006 RSE (30 feet)
– Amphenol GCA70 03007 RSE (50 feet)
Amphenol GCA70 03008 RSE (100 feet)
–
Amphenol GCA70 03009 RSE (250 feet)
–
Volex VLX979-30 (30 feet)
–
Volex VLX979-50 (50 feet)
–
Volex VLX979-100 (100 feet)
–
Volex VLX979-250 (250 feet)
–
Straight DS-1 cable
•
Installing Champ connector DS-1 cables requires 64-pin bundled cable
connectors with a 64-pin male Champ connector. You need Champ
connector #552285-1 for the plug side and #1-552496-1 for the right-angle
shell housing, or their functional equivalents.
NTP-B8 Install Wires to Alarm, Timing, LAN, and Craft Pin Connections,
page 1-28
As needed
Onsite
None
Pin Assignments for Champ Connector (the shaded area corresponds to the white/orange
binder group)
Pin Pin Signal/Wire
1 33 Tx Ring 1
blue/white
2 34 Tx Ring 2
orange/white
3 35 Tx Ring 3
green/white
4 36 Tx Ring 4
brown/white
Table 1-5
Signal/Wire Pin
Rx Tip 1 17
yellow/orange
Rx Tip 2 18
yellow/green
Rx Tip 3 19
yellow/brown
Rx Tip 4 20
yellow/slate
Chapter 1 Install Hardware
for the ONS 15327
Pin Signal/Wire
49 Rx Ring 1
orange/yellow
50 Rx Ring 2
green/yellow
51 Rx Ring 3
brown/yellow
52 Rx Ring 4
slate/yellow
March 2003