Table 10-8 Oc-N Card Line Settings - Cisco ONS 15327 Procedure Manual

NTP-B89 Modify Line Settings and PM Parameter Thresholds for Optical Ports
Double-click the OC-N card where you want to change the line settings.
Step 1
Click the Provisioning > Line tabs.
Step 2
Modify any of the settings listed in
Step 3
See Table C-3 on page C-8
default settings, or
Note

Table 10-8 OC-N Card Line Settings

Parameter
Port #
Port Name
SF BER
SD BER
Provides
Synch
EnableSync
Msg
Send
DoNotUse
PJSTSMon #
Cisco ONS 15327 Procedure Guide, R4.0
10-10
for OC-3 card default settings,
Table C-5 on page C-12
The STS subtab is used to provision intermediate path performance monitoring (IPPM). To
provision IPPM, circuits must be provisioned on the card.
Description
Port number (read-only)
Provides the ability to assign the
specified port a name
Sets the signal fail bit error rate
Sets the signal degrade bit error rate
If checked, the card is provisioned as a
network element timing reference
Enables synchronization status messages
(S1 byte), which allow the node to choose
the best timing source
When checked, sends a DUS (do not use)
message on the S1 byte
Sets the STS that will be used for pointer
justification. If set to 0, no STS is
monitored. Only one STS can be
monitored on each OC-N port.
Table 10-8.
Table C-4 on page C-10
for OC-48 card default settings.
Options
•
•
User-defined, up to 32 alphanumeric/
special characters. Blank by default.
See
page
•
•
•
•
•
•
•
•
•
•
(Read-only)
•
•
•
•
•
•
•
Chapter 10 Change Port Settings
for OC-12 card
1 to 4 (OC-3)
1 (OC-12, OC-48)
DLP-B314 Assign a Name to a Port,
5-16.
1E-3
1E-4 (default)
1E-5
1E-5
1E-6
1E-7 (default)
1E-8
1E-9
Yes (checked)
No (unchecked)
Yes (checked, default)
No (unchecked)
Yes (checked)
No (unchecked, default)
0 - 3 (OC-3, per port)
0 - 12 (OC-12)
0 - 48 (OC-48)
March 2003