Figure 5-7 Setting Attributes For A Vt Tunnel - Cisco ONS 15327 Procedure Manual

Chapter 5 Create Circuits and VT Tunnels
Inter-domain (UCP) SLA—If the tunnel will travel on a unified control plane (UCP) channel, enter
•
the service level agreement number. Otherwise, leave the field set to zero.
Figure 5-7
Click Next.
Step 6
Step 7 In the Circuit Source area, choose the node where the VT tunnel will originate from the Node drop-down
menu.
Click Next.
Step 8
Step 9 In the Circuit Destination area, choose the node where the VT tunnel will terminate from the Node
drop-down menu.
Step 10 Click Next.
Step 11 In the Circuit Routing Preferences area, choose Route Automatically. Two options are available; choose
either, both, or none based on your preferences.
• Using Required Nodes/Spans—Check this check box to specify nodes and spans to include or
exclude in the CTC-generated tunnel route.
• Review Route Before Creation—Check this check box to review and edit the VT tunnel route before
the circuit is created.
Step 12 If you selected Using Required Nodes/Spans:
a. Click Next.
In the Circuit Route Constraints area, click a span on the VT tunnel map.
b.
Click Include to include the node or span in the VT tunnel. Click Exclude to exclude the node or
c.
span from the VT tunnel. The order in which you choose included nodes and spans sets the VT
tunnel sequence. Click spans twice to change the circuit direction.
d. Repeat Step
Review the VT tunnel route. To change the tunnel routing order, choose a node in the Required
e.
Nodes/Lines or Excluded Notes Links lists, then click the Up or Down buttons to change the tunnel
routing order. Click Remove to remove a node or span.
Step 13 If you selected Review Route Before Creation:
Click Next.
a.
March 2003
Setting Attributes for a VT Tunnel
c for each node or span you wish to include or exclude.
NTP-B133 Create an Automatically Routed VT Tunnel
Cisco ONS 15327 Procedure Guide, R4.0
5-31