Dlp-B120 Discontinue Alarm Suppression - Cisco ONS 15327 Procedure Manual

NTP-B72 Suppress and Discontinue Alarm Suppression
To suppress DS-1 port alarms, click the Provisioning > DS1 > Alarm Behavior tabs. To suppress DS-3
Step 9
port alarms, click the Provisioning > DS3 > Alarm Behavior tabs
Check the Suppress Alarms column check box for each port where you want to enable alarm reporting.
Step 10
Return to your originating procedure (NTP).
Step 11

DLP-B120 Discontinue Alarm Suppression

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view click the Provisioning > Alarm Behavior tabs. To discontinue suppression for optical
Step 1
cards, proceed to
Note
To discontinue alarm suppression at the node level for optical cards, uncheck the Suppress Alarms
Step 2
check box at the lower-left of the Alarm Behavior window.
Click Apply.
Step 3
To discontinue alarm suppression at the card level for optical ports, double-click the card to display the
Step 4
card view.
Uncheck the Suppress Alarms check box for the port(s) you no longer want to suppress.
Step 5
Click Apply.
Step 6
To discontinue alarm suppression for DS-1 or DS-3 ports, double-click the XTC card graphic at the node
Step 7
view.
To discontinue DS-1 port alarm suppression, click the Provisioning > DS1 > Alarm Behavior tabs. To
Step 8
discontinue DS-3 port alarm suppression, click the Provisioning > DS3 > Alarm Behavior tabs.
Uncheck the Suppress Alarms column check box for each port where you want to discontinue alarm
Step 9
reporting.
Return to your originating procedure (NTP).
Step 10
Cisco ONS 15327 Procedure Guide, R4.0
6-32
Use this task to discontinue alarm suppression and reenable alarm
reporting on a port, card, or node.
None
DLP-B119 Suppress Alarm Reporting, page 6-31
DLP-B60 Log into CTC, page 2-23
As needed
Onsite or remote
Provisioning or higher
Step 2. To discontinue suppression for electrical ports, proceed to
You must restore alarm reporting at the view where it was originally suppressed.
Chapter 6 Manage Alarms
(Figure 6-11 on page 6-23).
Step 4.
November 2004