Ntp-B89 Modify Line Settings And Pm Parameter Thresholds For Optical Ports; Dlp-B170 Change Line Settings For Oc-N Cards - Cisco ONS 15327 Procedure Manual

Chapter 10 Change Port Settings
Note
Return to your originating procedure (NTP).
Step 8
NTP-B89 Modify Line Settings and PM Parameter Thresholds for
Optical Ports
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
card settings. If you are already logged in, continue with Step 2.
Complete the
Step 2
Perform any of the following tasks as needed:
Step 3
•
•
•
Step 4 Complete the
Stop. You have completed this procedure.

DLP-B170 Change Line Settings for OC-N Cards

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
March 2003
The threshold value displays after the circuit is created.
This procedure changes the line and threshold settings for optical cards and
ports. The default OC-N card settings are provided in the
Settings" section on page
None
As needed
Onsite or remote
Provisioning or higher
"DLP-B60 Log into CTC" task on page 2-23
"NTP-B108 Back Up the Database" procedure on page
DLP-B170 Change Line Settings for OC-N Cards, page 10-9
DLP-B171 Change SONET Thresholds Settings for OC-N Cards, page 10-11
DLP-B172 Change an Optical Port to SDH, page 10-14
"NTP-B108 Back Up the Database" procedure on page
This task changes the line settings for OC-N cards.
None
DLP-B60 Log into CTC, page 2-23
As needed
Onsite or remote
Provisioning or higher

NTP-B89 Modify Line Settings and PM Parameter Thresholds for Optical Ports

C-4.
at the node where you want to change the
Cisco ONS 15327 Procedure Guide, R4.0
"Card Default
14-6.
14-6.
10-9