Dlp-B253 Provision Sonet Dcc Terminations - Cisco ONS 15327 Procedure Manual

Chapter 4 Turn Up Network

DLP-B253 Provision SONET DCC Terminations

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view click the Provisioning > SONET DCC tabs.
Step 1
Click Create.
Step 2
Step 3 In the Create SDCC Terminations dialog box click the ports where you want to create the DCC
termination. To select more than one port, press the Shift key or the Ctrl key.
Note
Under Port State, click the Set to IS radio button.
Step 4
Step 5 Verify that the Disable OSPF on DCC Link check box is unchecked.
Step 6 Click OK.
Note
Note
Return to your originating procedure (NTP).
Step 7
March 2003
This task creates the SONET Data Communications Channel terminations
required for alarms, administration, data, signal control information, and
messages.
None
DLP-B60 Log into CTC, page 2-23
As needed
Onsite or remote
Provisioning or higher
SDCC refers to the Section DCC, which is used for ONS 15327 DCC terminations. The SONET
Line DCCs and the Section DCC (when not used as a DCC termination by the ONS 15327) can
be provisioned as DCC tunnels. See the
EOC (DCC Termination Failure) and LOS (Loss of Signal) alarms are present until you create
all network DCC terminations and put the DCC termination OC-N ports in service.
There are four possibilities for the appearance of DCCs: green/solid, green/dashed, gray/solid,
gray/dashed. DCC appearance corresponds to the following states: active/routable,
active/nonroutable, failed/routable, or failed/nonroutable. Circuit provisioning uses
active/routable links. Selecting a node or span in the graphic area displays information about the
node and span in the status area.
NTP-B124 Provision a Point-to-Point Network
"DLP-B313 Create a DCC Tunnel" task on page
Cisco ONS 15327 Procedure Guide, R4.0
5-80.
4-5