Ntp-B186 Create A Unidirectional Ds-3 Circuit With Multiple Drops - Cisco ONS 15327 Procedure Manual

NTP-B186 Create a Unidirectional DS-3 Circuit with Multiple Drops

Click Finish. If you entered more than 1 in the Number of Circuits field, the Circuit Creation dialog box
Step 15
appears for you to create the remaining circuits. Repeat this procedure for each additional circuit.
When all the circuits are created, CTC displays the main Circuits window. Verify that the circuit(s) you
Step 16
created appear in the window.
Complete the
Step 17
test circuit.
Stop. You have completed this procedure.
NTP-B186 Create a Unidirectional DS-3 Circuit with Multiple
Drops
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
create the circuit. If you are already logged in, continue with
If you want to assign a name to the circuit source and destination ports before you create the circuit,
Step 2
complete the
From the View menu choose Go to Network View.
Step 3
Click the Circuits tab, then click Create.
Step 4
In the Circuit Creation dialog box
Step 5
•
•
•
•
•
•
•
Cisco ONS 15327 Procedure Guide, R4.0
5-24
"NTP-B135 Test Electrical Circuits" procedure on page
This procedure creates a unidirectional DS-3 circuit with multiple drops.
None
NTP-B127 Verify Network Turn Up, page 5-3
As needed
Onsite or remote
Provisioning or higher
"DLP-B60 Log into CTC" task on page 2-23
"DLP-B314 Assign a Name to a Port" task on page
Name—Assign a name to the circuit. The name can be alphanumeric and up to 48 characters
(including spaces). Circuit names should be 44 characters or less if you want the ability to create
monitor circuits. If you leave the field blank, CTC assigns a default name to the circuit.
Type—Choose STS.
Size—Choose STS-1.
Bidirectional—Uncheck for this circuit.
Number of circuits—Leave the default unchanged (1).
Auto-ranged—Unavailable when the Number of Circuits is 1.
State—Choose a service state to apply to the circuit:
IS—The circuit is in service.
–
OOS—The circuit is out of service. Traffic is not passed on the circuit.
–
OOS-AINS—The circuit is out of service until it receives a valid signal, at which time the
–
circuit state automatically changes to in service (IS).
at a node on the network where you will
(Figure 5-6 on page 5-25), complete the following fields:
Chapter 5 Create Circuits and VT Tunnels
5-37. Skip this step if you built a
Step 2.
5-16. If not, continue with Step 3.
March 2003