Dlp-B96 Provision A Ds-1 Or Ds-3 Circuit Route - Cisco ONS 15327 Procedure Manual
Hide thumbs
Also See for ONS 15327:
- User documentation (559 pages) ,
- Manual (42 pages) ,
- Reference manual (166 pages)
Table of Contents
Advertisement
Chapter 5
Create Circuits and VT Tunnels
DLP-B96 Provision a DS-1 or DS-3 Circuit Route
Purpose
Tools/Equipment
Prerequisite Procedures You perform this task during one of the following procedures:
Required/As Needed
Onsite/Remote
Security Level
Step 1
On the Circuit Creation wizard in the Route Review and Edit area, click the source node icon if it is not
already selected.
Step 2
Starting with a span on the source node, click the arrow of the span you want the circuit to travel. The
arrow turns white. In the Selected Span area, the From and To fields display span information. The
source STS and VT (DS-1 circuit only) appear.
If you want to change the source STS, adjust the Source STS field; otherwise, continue with
Step 3
Step 4
If you want to change the source VT for DS-1 circuits, adjust the Source VT field; otherwise, continue
with
Note
Step 5
Click Add Span.The span is added to the Included Spans list and the span arrow turns blue.
Repeat Steps
Step 6
all intermediary nodes. If the Fully Protect Path field is checked on the Circuit Routing Preferences
panel, you must:
•
•
Return to your originating procedure (NTP).
Step 7
March 2003
This task provisions the circuit route for manually-routed DS-1 or DS-3
circuits.
None
NTP-B182 Create a Manually Routed DS-1 Circuit, page
NTP-B183 Create a Unidirectional DS-1 Circuit with Multiple Drops, page
5-13, or
NTP-B185 Create a Manually Routed DS-3 Circuit, page
NTP-B186 Create a Unidirectional DS-3 Circuit with Multiple Drops, page
5-24
As needed
Onsite or remote
Provisioning or higher
Step
5.
VT is gray (unavailable) for DS-3 circuits.
2
through
5
until the circuit is provisioned from the source to the destination node through
Add two spans for all path protection or unprotected portions of the circuit route from the source to
the destination
Add one span for all BLSR or 1+1 portions of route from the source to the destination
NTP-B186 Create a Unidirectional DS-3 Circuit with Multiple Drops
Cisco ONS 15327 Procedure Guide, R4.0
5-10, or
5-22, or
Step
4.
5-29
Advertisement
Table of Contents
