Ntp-B189 Create A Manually Routed Optical Circuit - Cisco ONS 15327 Procedure Manual

Chapter 5 Create Circuits and VT Tunnels
•
•
On the Circuits window, verify that the circuit(s) you created appear in the circuits list.
Step 16
Complete the
Step 17
circuit.
Stop. You have completed this procedure.

NTP-B189 Create a Manually Routed Optical Circuit

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
create the circuit. If you are already logged in, continue with
If you want to assign a name to the tunnel source and destination ports before you create the circuit,
Step 2
complete the
From the View menu choose Go to Network View.
Step 3
In the Circuit Creation dialog box, complete the following fields:
Step 4
•
•
•
•
•
•
•
March 2003
If you entered more than 1 in Number of circuits and did not choose Auto-ranged, the Circuit
Creation dialog box appears for you to create the remaining circuits. Repeat Steps
15 for each additional circuit.
After completing the circuit(s), CTC displays the Circuits window.
"NTP-B62 Test Optical Circuits" procedure on page
This procedure creates a manually-routed, bidirectional or unidirectional
optical circuit, including STS-1 and concatenated STS-3c, STS-6c,
STS-9c, STS-12c, STS-24c, or STS-48c speeds.
None
NTP-B127 Verify Network Turn Up, page 5-3
As needed
Onsite or remote
Provisioning or higher
"DLP-B60 Log into CTC" task on page 2-23
"DLP-B314 Assign a Name to a Port" task on page
Name—Assign a name to the circuit. The name can be alphanumeric and up to 48 characters
(including spaces). Circuit names should be 44 characters or less if you want the ability to create
monitor circuits. If you leave the field blank, CTC assigns a default name to the circuit.
Type—Choose STS.
Size—Choose the optical circuit size. Choices are STS-1, STS-3c, STS-6c, STS-9c, STS-12c,
STS-24c, or STS-48c.
Bidirectional—Leave checked for this circuit.
Number of circuits—Type the number of optical circuits you want to create. The default is 1.
Auto-ranged—Applies to automatically-routed circuits only. If you entered more than 1 in Number
of Circuits, uncheck this check box. (The check box is unavailable if only one circuit is entered in
Number of Circuits.)
State—Choose a service state to apply to the circuit:
IS—The circuit is in service.
–
OOS—The circuit is out of service. Traffic is not passed on the circuit.
–
NTP-B189 Create a Manually Routed Optical Circuit
5-51. Skip this step if you built a test
at a node on the network where you will
Step 2.
5-16. If not, continue with
Cisco ONS 15327 Procedure Guide, R4.0
Step 5 through
Step 3.
5-43