Cisco ONS 15327 Procedure Manual page 419

Chapter 14 Maintain the Node
If you need to install or replace one or more XTC cards, see the
Step 1
on page
If you are using Microsoft Windows, complete the
Step 2
the Database and Upload Software (Windows)" task on page
If you are using UNIX, complete the
Step 3
and Upload Software (UNIX)" task on page
Stop. You have completed this procedure.
DLP-B244 Use the Reinitialization Tool to Clear the Database and Upload
Software (Windows)
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note The XTC cards reboot several times during this procedure. Wait until they are completely rebooted
before continuing.
Step 1 Insert the system software CD containing the reinitialization tool, the CTC software, and the defaults
database into the local craft interface PC drive. If the CTC Installation Wizard opens, click Cancel.
Step 2 To find the recovery tool file, go to Start > Run > Browse and select the CD drive.
On the CD drive, go to the CISCO15327 folder and set the Files of Type drop-down menu to All Files.
Step 3
Select the RE-INIT.jar file and click Open to open the reinitialization tool
Step 4
March 2003
1-21.
This task describes how to use the reinitialization tool in Windows. Use
this tool to clear the database on the XTC, upload software, and restore
factory or customer defaults.
Software CD containing Release 4.0 software, the NE defaults, and the
reinitialization tool
JRE 1.03_02 must also be installed on the computer you use to perform
this procedure.
Straight-through (Category 5) LAN cable
NTP-B108 Back Up the Database, page 14-6
As needed
Onsite
Superuser
NTP-B163 Restore the Node to Factory Configuration
"NTP-B 217 Install the XTCs" procedure
"DLP-B 244 Use the Reinitialization Tool to Clear
14-11.
"DLP-B 245 Use the Reinitialization Tool to Clear the Database
14-13.
Cisco ONS 15327 Procedure Guide, R4.0
(Figure 14-10).
14-11