Dlp-B317 View Optical Oc-N Pm Parameters - Cisco ONS 15327 Procedure Manual

Chapter 7 Monitor Performance
Click the Refresh button. The PM counts for the newly-selected auto-refresh time interval appear.
Step 5
Depending on the selected auto-refresh interval, the displayed PM counts automatically update when
each refresh interval completes. If the auto-refresh interval is set to None, the displayed PM counts are
not updated unless you click the Refresh button.
Return to your originating procedure (NTP).
Step 6

DLP-B317 View Optical OC-N PM Parameters

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click an OC-N card. The card view appears.
Step 1
Click the Performance tab
Step 2
Figure 7-5
Card View
Performance
Auto-refresh
radio buttons
Directions
radio buttons
March 2003
(Figure 7-4 on page
Viewing Optical Performance Monitoring Information
Refresh
Port
Intervals
This task enables you to view PM counts on a selected optical (OC-N)
card and port to detect possible performance problems.
None
DLP-B60 Log into CTC, page 2-23
As needed
Onsite or remote
Retrieve or higher
7-7).
NTP-B195 Monitor Electrical or Optical Performance
Baseline Clear
Cisco ONS 15327 Procedure Guide, R4.0
7-13