Ntp-B151 Modify Circuit Characteristics; Dlp-B230 Change A Circuit State - Cisco ONS 15327 Procedure Manual

NTP-B151 Modify Circuit Characteristics

NTP-B151 Modify Circuit Characteristics
Purpose
Tools/Equipment
Prerequisite Procedures Circuits must exist on the network. See
Required/As Needed
Onsite/Remote
Security Level
Log into the network containing the circuit you want to modify. See the
Step 1
on page 2-23
As needed, complete the
Step 2
As needed, complete the
Step 3
As needed, complete the
Step 4
Stop. You have completed this procedure.

DLP-B230 Change a Circuit State

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Click the Circuits tab.
Step 1
Click the circuit with the state you want to change.
Step 2
Note
From the Tools menu, choose Circuits > Set Circuit State.
Step 3
Note
In the Set Circuit State dialog box
Step 4
choices from the Target Circuit State drop-down menu:
•
Cisco ONS 15327 Procedure Guide, R4.0
8-8
This procedure modifies the properties of ONS 15327 circuits.
None
Tunnels"
As needed
Onsite or remote
Provisioning or higher
for instructions. If you are already logged in, continue with Step 2.
"DLP-B231 Edit a Circuit Name" task on page
"DLP-B232 Change Active and Standby Span Color" task on page
"DLP-B233 Edit Path Protection Circuit Path Selectors" task on page
Use this task to change the state of a circuit.
None
DLP-B60 Log into CTC, page 2-23
As needed
Onsite or remote
Provisioning or higher
You cannot edit the circuit state if the circuit is routed to nodes with a CTC software release older
than Release 3.4. These circuits will automatically be in service (IS).
Alternatively, you can click the Edit button, then click the State tab on the Edit Circuits window.
IS—Places the circuit in service
for circuit creation procedures.
(Figure 8-1) change the circuit state by choosing one of the following
Chapter 8 Manage Circuits
Chapter 5, "Create Circuits and VT
"DLP-B60 Log into CTC" task
8-9.
8-10.
March 2003
8-11.