Cisco ONS 15327 Procedure Manual page 232

NTP-B145 Create an E-Series Multicard EtherSwitch Manual Cross-Connect
–
–
Apply to drop ports—Uncheck this check box.
•
• Create cross-connects only (TL1-like)—Uncheck this check box.
• Inter-domain (UCP) SLA—If the circuit will travel on a unified control plane (UCP) channel, enter
the service level agreement number. Otherwise, leave the field set to zero.
• Protected Drops—Leave the default unchanged (unchecked).
If the circuit will be routed on a path protection, complete the
Step 8
Selectors During Circuit Creation" task on page
Step 9 Click Next.
Provision the cross-connect source:
Step 10
From the Node drop-down menu choose the cross-connect source node.
a.
From the Slot drop-down menu choose Ethergroup.
b.
Click Next.
Step 11
From the Node drop-down menu in the Destination area, choose the circuit source node selected in
Step 12
Step 10. For Ethernet cross-connects, the source and destination nodes are the same.
The Slot field is provisioned automatically for Ethergroup.
Click Next.
Step 13
Step 14 Review the VLANs listed in the Available VLANs area. If the VLAN you want to use appears, continue
with Step
Click the New VLAN button.
a.
b. On the New VLAN dialog box, complete the following:
–
–
Click OK.
c.
In the Available VLANs column, click the VLAN you want to use and click the arrow button (>>) to
Step 15
move the VLAN to the Circuit VLANs column.
Click Next.
Step 16
The Circuit Creation (Circuit Routing Preferences) dialog box opens.
Verify the cross-connect information (in this step, "circuit" refers to the Ethernet cross-connect):
Step 17
Circuit name
•
Circuit type
•
Circuit size
•
Cisco ONS 15327 Procedure Guide, R4.0
5-66
OOS-AINS—The circuit is out of service until it receives a valid signal, at which time the
circuit state automatically changes to in service (IS).
OOS-MT—The circuit is in a maintenance state. The maintenance state does not interrupt traffic
flow; it suppresses alarms and conditions and permits loopbacks on the circuit. Use OOS-MT
for circuit testing or to suppress circuit alarms temporarily. Change the state to IS, OOS, or
OOS-AINS when testing is complete. See the
page 8-8.
16. If you need to create a new VLAN, complete the following steps:
VLAN Name—Assign an easily-identifiable name to your VLAN.
VLAN ID—Assign a VLAN ID. The VLAN ID should be the next available number between 2
and 4093 that is not already assigned to an existing VLAN. Each ONS 15327 network supports
a maximum of 509 user-provisionable VLANs.
Chapter 5
"DLP-B230 Change a Circuit State" task on
"DLP-B218 Provision Path Protection
5-27.
Create Circuits and VT Tunnels
March 2003