Dlp-B65 Create A Static Route - Cisco ONS 15327 Procedure Manual

Chapter 3 Turn Up Node
Click Yes on the confirmation dialog box.
Step 5
Both XTC cards will reboot, one at a time, which will take 10 to 15 minutes. Eventually, a "Lost node
connection, switching to network view" message is displayed.
Step 6 Click OK. CTC displays the network view. The node icon is displayed in grey, during which time you
cannot access the node.
Step 7 Double-click the node icon when it becomes green.
Return to your originating procedure (NTP).
Step 8

DLP-B65 Create a Static Route

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
From the View menu choose Go to Network View.
Step 1
Click the Provisioning > Network tabs.
Step 2
Step 3 Click the Static Routing tab. Click Create.
Step 4 In the Create Static Route dialog box enter the following:
•
•
•
•
Click OK. Verify that the static route displays in the Static Route window.
Step 5
March 2003
This task creates a static route to establish CTC connectivity to a computer
on another network.
None
DLP-B60 Log into CTC, page 2-23
Required if either of the following is true:
•
•
Onsite or remote
Provisioning or higher
Destination—Enter the IP address of the computer running CTC. To limit access to one computer,
enter the full IP address and a subnet mask of 255.255.255.255. To allow access to all computers on
the 192.168.1.0 subnet, enter 192.168.1.0 and a subnet mask of 255.255.255.0. You can enter a
destination of 0.0.0.0 to allow access to all CTC computers that connect to the router.
Mask—Enter a subnet mask. If the destination is a host route (i.e., one CTC computer), enter a 32-bit
subnet mask (255.255.255.255). If the destination is a subnet, adjust the subnet mask accordingly,
for example, 255.255.255.0. If the destination is 0.0.0.0, CTC automatically enters a subnet mask
of 0.0.0.0 to provide access to all CTC computers. You cannot change this value.
Next Hop—Enter the IP address of the router port or the node IP address if the CTC computer is
connected to the node directly.
Cost—Enter the number of hops between the ONS 15327 and the computer.
You need to connect ONS 15327s to CTC sessions on one subnet
connected by a router to ONS 15327s residing on another subnet when
OSPF is not enabled, and the Enable Proxy check box is not selected.
You need to enable multiple CTC sessions among ONS 15327s
residing on the same subnet and when the Craft Access Only feature is
not enabled.
NTP-B169 Set Up CTC Network Access
Cisco ONS 15327 Procedure Guide, R4.0
3-9