Dlp-B97 Provision An Optical Circuit Source And Destination - Cisco ONS 15327 Procedure Manual

NTP-B190 Create a Unidirectional Optical Circuit with Multiple Drops
d.
e.
If you need to create additional drops on the circuit, repeat Steps
Step 21
Click Close. The Circuits window appears.
Step 22
Verify that the new drops appear in the Destination column for the circuit you edited. If they do not
Step 23
appear, repeat Steps
Complete the
Step 24
Stop. You have completed this procedure.

DLP-B97 Provision an Optical Circuit Source and Destination

Purpose
Tools/Equipment
Prerequisite Procedures Perform this task during one of the following procedures:
Required/As Needed
Onsite/Remote
Security Level
Step 1 From the Node drop-down menu choose the node where the circuit will originate.
Step 2 From the Slot drop-down menu choose the slot containing the optical card where the circuit originates.
(If a card's capacity is fully utilized, it does not appear in the menu.)
Step 3 Depending on the circuit origination card, choose the source port and/or STS from the Port and STS
sub-menus. The Port menu is only available if the card has multiple ports. STSs are not displayed if they
are already in use by other circuits.
Note
Cisco ONS 15327 Procedure Guide, R4.0
5-48
The routing preferences for the new drop will match those of the original circuit. However, you can
modify the following:
If the original circuit was routed on a protected path, you can change the nodal diversity options:
–
Required, Desired, Don't Care; Link Diverse only. See
If the original circuit was not routed on a protected path, the Protection Channel Access options
–
is available. See Step 13
Click OK. The new drop appears in the Drops list.
19 through
"NTP-B62 Test Optical Circuits" procedure on page
This task provisions the source and destination cards for an optical circuit.
None
NTP-B188 Create an Automatically Routed Optical Circuit, page 5-39
NTP-B189 Create a Manually Routed Optical Circuit, page 5-43
NTP-B190 Create a Unidirectional Optical Circuit with Multiple Drops,
page 5-45
As needed
Onsite or remote
Provisioning or higher
The STSs that display depend on the card, circuit size, and protection scheme. For example, if
you create an STS-3c circuit on an OC-12 card in a path protection, only four STSs are available.
If you create an STS-3c circuit on an OC-12 card in a BLSR, two STSs are available because of
the BLSR protection characteristics.
for a description of the PCA option.
22 making sure all options are provisioned correctly.
Chapter 5 Create Circuits and VT Tunnels
Step 11 for options descriptions.
18 through 20.
5-51.
March 2003