Cisco ONS 15327 Procedure Manual page 148
Hide thumbs
Also See for ONS 15327:
- User documentation (559 pages) ,
- Manual (42 pages) ,
- Reference manual (166 pages)
Table of Contents
Advertisement
NTP-B126 Create a BLSR
Click Next. If CTC displays a network graphic, go to Step 7. If CTC determines that a BLSR cannot be
Step 6
created, for example, not enough optical cards are installed or it finds circuits with path protection
selectors, a "Cannot Create BLSR" message appears. If this occurs, complete the following steps:
Click OK.
a.
On the Create BLSR window, click Excluded Nodes. Review the information explaining why the
b.
BLSR could not be created, then click OK.
Depending on the problem, click Back to start over or click Cancel to cancel the operation.
c.
Complete the
d.
completed accurately, then start this procedure again.
In the network graphic, double-click a BLSR span line. If the span line is DCC connected to other BLSR
Step 7
cards comprising a complete ring, the lines turn blue and the Finish button appears. If the lines do not
form a complete ring, double-click span lines until a complete ring is formed. When the ring is DCC
connected, go to
Step 8
Click Finish. If CTC displays the BLSR window with the BLSR you created, go to
displays a "Cannot Create BLSR" or "Error While Creating BLSR" message:
a.
Click OK.
On the Create BLSR window, click Excluded Nodes. Review the information explaining why the
b.
BLSR could not be created, then click OK.
c.
Depending on the problem, click Back to start over or click Cancel to cancel the operation.
Complete the
d.
completed accurately, then start this procedure again.
Note
Verify the following:
Step 9
On the network view graphic, a green span line appears between all BLSR nodes.
•
All E-W MISMATCH, RING MISMATCH, APSCIMP, DFLTK, and BLSROSYNC alarms are
•
cleared. See the Cisco ONS 15327 Troubleshooting Guide for alarm troubleshooting.
Complete the
Step 10
Stop. You have completed this procedure.
Cisco ONS 15327 Procedure Guide, R4.0
4-16
"NTP-B40 Provision BLSR Nodes" procedure on page
Step
8.
"NTP-B40 Provision BLSR Nodes" procedure on page
Some or all of the following alarms may briefly appear during BLSR setup: E-W MISMATCH,
RING MISMATCH, APSCIMP, APSDFLTK, or BLSROSYNC.
"NTP-B175 BLSR Acceptance Test" procedure on page
Chapter 4
Turn Up Network
4-14, making sure all steps are
Step
9. If CTC
4-14, making sure all steps are
4-17.
March 2003
Advertisement
Table of Contents
