Dlp-B98 Provision An Optical Circuit Route - Cisco ONS 15327 Procedure Manual

Chapter 5 Create Circuits and VT Tunnels
If you need to create a secondary source, for example, a path protection bridge/selector circuit entry
Step 4
point in a multivendor path protection, click Use Secondary Source and repeat Steps
define the secondary source.
Click Next.
Step 5
From the Node drop-down menu choose the destination node.
Step 6
From the Slot drop-down menu choose the slot containing the optical card where the circuit will
Step 7
terminate (destination card). (If a card's capacity is fully utilized, the card does not appear in the menu.)
Depending on the card selected in Step 2, choose the destination port and/or STS from the Port and STS
Step 8
sub-menus. The Port menu is available only if the card has multiple ports. The STSs that display depend
on the card, circuit size, and protection scheme.
If you need to create a secondary destination, for example, a path protection bridge/selector circuit entry
Step 9
point in a multivendor path protection, click Use Secondary Destination and repeat Steps
to define the secondary destination.
Step 10 Click Next.
Step 11 Return to your originating procedure (NTP).

DLP-B98 Provision an Optical Circuit Route

Purpose
Tools/Equipment
Prerequisite Procedures Perform this task during one of the following procedures:
Required/As Needed
Onsite/Remote
Security Level
On the Circuit Creation wizard in the Route Review and Edit area, click the source node icon if it is not
Step 1
already selected.
Starting with a span on the source node, click the arrow of the span you want the circuit to travel. The
Step 2
arrow turns white. In the Selected Span area, the From and To fields display span information. The
source STS appears.
March 2003
NTP-B190 Create a Unidirectional Optical Circuit with Multiple Drops
This task provisions an optical circuit route for manually-routed circuits.
None
NTP-B188 Create an Automatically Routed Optical Circuit, page 5-39
NTP-B189 Create a Manually Routed Optical Circuit, page 5-43
NTP-B190 Create a Unidirectional Optical Circuit with Multiple Drops,
page 5-45
As needed
Onsite or remote
Provisioning or higher
Figure 5-12 shows an example.
Cisco ONS 15327 Procedure Guide, R4.0
1 through 3 to
6 through 8
5-49