Cisco ONS 15327 Procedure Manual page 170

NTP-B127 Verify Network Turn Up
Note
Step 3 Verify node accessibility. In the network view, all node icons must be either green, yellow, orange, or red.
If all network nodes do not appear after a few minutes, or if a node icon is gray with an IP address under
it, do not continue. Look at the Net box in the lower right corner of the window. If it is gray, log in again,
making sure not to check the Disable Network check box on the CTC Login dialog box. If problems
persist, see
network topology, or refer to the Cisco ONS 15327 Troubleshooting Guide for troubleshooting
procedures.
Verify DCC connectivity. All nodes must be connected by green lines. If lines are missing or gray in
Step 4
color, do not continue. See
appropriate for your network topology. Verify that all nodes have DCC connectivity before continuing.
Investigate and resolve, if necessary, all critical (red node icon) or major (orange node icon) alarms.
Step 5
Click the Alarms tab to view alarm descriptions. Refer to the Cisco ONS 15327 Troubleshooting Guide
to resolve alarms before continuing.
From the View menu choose Go to Home View. Verify that the node is provisioned according to your
Step 6
site or engineering plan:
View the cards on the shelf map. Verify that the ONS 15327 cards appear in the specified slots.
a.
Click the Provisioning > General tabs. Verify that the node name, contacts, date, time, and
b.
NTP/SNTP server IP address (if used) are correctly provisioned. If needed, make corrections using
the"NTP-B81 Change Node Management Information" procedure on page
Click the Network tab. Verify that the IP address, Subnet mask, Default Router, Prevent LCD IP
c.
Config, and Gateway Settings are correctly provisioned. If not, make corrections using the
"NTP-B201 Change CTC Network Access" procedure on page
d. Click the Protection tab. Verify that protection groups are created as specified in your site plan. If
the protection groups are not created, complete the
procedure on page
If the node is in a BLSR, click the BLSR tab. (If the node is not in a BLSR, continue with Step f.)
e.
Verify that the following items are provisioned as specified in your site plan:
–
–
–
–
If you need to make corrections, see the
for instructions.
Click the Security tab. Verify that the users and access levels are provisioned as specified. If not,
f.
see the
information.
g. If SNMP is used, click the SNMP tab and verify the trap and destination information. If the
information is correct, see the
correct the information.
Cisco ONS 15327 Procedure Guide, R4.0
5-4
If this is the first time your computer has connected to this ONS 15327 network, the node icons
will be stacked on the left side of the graphic area, possibly out of view. Use the scroll bar below
the network map to display the icons. To separate the icons press Ctrl and drag and drop the icon
to the new location. Repeat until all the nodes are visible on the graphic area.
Chapter 4, "Turn Up Network"
Chapter 4, "Turn Up Network"
3-20.
BLSR type (2-Fiber)
BLSR ring ID and node IDs
Ring reversion time
East and west card assignments
"NTP-B30 Create Users and Assign Security" procedure on page 3-3
to review the network turn-up procedure appropriate for your
and follow the network turn-up procedure
"NTP-B170 Create Optical Protection Groups"
"NTP-B40 Provision BLSR Nodes" procedure on page 4-14
"NTP-B87 Change SNMP Settings" procedure on page 9-23
Chapter 5 Create Circuits and VT Tunnels
9-2.
9-4.
to correct the
March 2003
to