Ntp-B105 Add A Path Protection Node - Cisco ONS 15327 Procedure Manual

Chapter 13 Add and Remove Nodes
Click the Provisioning > BLSR tabs.
Step 2
Highlight the ring and click Delete.
Step 3
In the Suggestion dialog box, click OK.
Step 4
In the confirmation message, confirm that this is the ring you want to delete. If so, click Yes.
Step 5
Return to your originating procedure (NTP).
Step 6

NTP-B105 Add a Path Protection Node

Purpose
Tools/Equipment
Prerequisite Procedures Cards must be installed and node turnup procedures completed on the node
Required/As Needed
Onsite/Remote
Security Level
Step 1 Verify the card installation on the new node. See the
page
Verify that the OC-N cards that will serve as the path protection trunk (span) cards match the path
Step 2
protection optical rate of the trunk cards to which the new node will be connected. For example, if the
adjacent nodes have OC-48 line cards, the new node must have OC-48 cards installed. If the OC-N cards
are not installed or the rate does not match the rate of the adjacent node trunk cards, complete the
"NTP-B218 Install the Optical and Ethernet Cards" procedure on page 1-23
Verify that fiber is available to connect the new node to the existing nodes.
Step 3
Complete the
Step 4
Log into a node in the path protection where you want to add a node. See the
Step 5
task on page 2-23
must be an authorized user on the node and you must have IP connectivity to the node.
Complete the
Step 6
verify that the path protection is free of major alarms or problems. If trouble is indicated (for example,
a major alarm exists), resolve the problem before proceeding. See
necessary, refer to the Cisco ONS 15327 Troubleshooting Guide.
Log into the new node:
Step 7
•
•
March 2003
This procedure adds a node to a path protection.
None
that will be added to the path protection. See
Hardware,"
NTP-B108 Back Up the Database, page 14-6
As needed
Onsite
Provisioning or higher
3-2.
"NTP-B35 Verify Node Turn Up" procedure on page
for instructions. In order to have CTC visibility to the new node after it is added, you
"DLP-B302 Check BLSR or Path Protection Alarms and Conditions" task on page 13-5
If the node has a LAN connection and is displayed on the network map, from the View menu, choose
Go to Other Node, then choose the new node from the Select Node to Go to pull-down menu on the
Select Node dialog box and click OK.
If the new node is not connected to the network, log into it directly using the
CTC" task on page 2-23.
and Chapter 3, "Turn Up Node."
"NTP-B24 Verify Card Installation" procedure on
Cisco ONS 15327 Procedure Guide, R4.0
NTP-B105 Add a Path Protection Node
Chapter 1, "Install
to install them.
4-2.
"DLP-B60 Log into CTC"
Chapter 6, "Manage Alarms"
"DLP-B60 Log into
to
or, if
13-13