Related Drive Parameters - YASKAWA SI-EP3 Installation Manual

6

Related Drive Parameters

The parameters in Table 7
of all parameters in
packaged with the drive for details on setting parameters.
Note: Hex.: MEMOBUS addresses that you can use to change parameters over network
communication are represented in hexadecimal numbers.
No.
(Hex.)
b1-01
(0180) Reference 1 Source
<1>
b1-02
(0181) Run Command 1 Source
<1>
F6-01 Communication Error
(03A2) Selection
F6-02 Comm External Fault
(03A3) (EF0) Detect
F6-03 Comm External Fault
(03A4) (EF0) Select
F6-06
Torque Reference/Limit by
(03A7)
Comm
<5>
F6-07 MultiStep Ref Priority
(03A8) Select
YASKAWA ELECTRIC TOBP C730600 89D YASKAWA AC Drive Option SI-EP3 Installation Manual
set the drive for operation with the option. Confirm proper setting
Table 7 before starting network communications. Refer to the manual
Table 7 Related Parameter Settings
Name
Selects the input method for frequency reference.
0: Keypad
1: Analog Input
2: Memobus/Modbus Communications
3: Option PCB
4: Pulse Train Input
Selects the input method for the Run command.
0: Keypad
1: Digital Input
2: Memobus/Modbus Communications
3: Option PCB
Selects drive response when a bUS error is detected
during communications with the option.
0: Ramp to Stop
1: Coast to Stop
2: Fast Stop (Use C1-09)
3: Alarm Only
4: Alarm - Run at d1-04
5: Alarm - Ramp to Stop
Selects the condition for external fault detection (EF0).
0: Always detected
1: Detection during run only
Selects drive response for external fault input (EF0)
detection during option communications.
0: Ramp to Stop
1: Coast to Stop
2: Fast Stop (Use C1-09)
3: Alarm Only
Enabling this parameter allows d5-01 to determine
whether the value is read as the Torque Limit value
(d5-01 = 0) or the Torque Reference value (d5-01 = 1).
0: Disabled
1: Enabled
0: MultiStep References Disabled
1: MultiStep References Enabled
6 Related Drive Parameters
Description
<2>
<2> <3>
<3>
<2>
<6>
Values
Default: 1
Range: 0 to 4
(Set to 3)
Default: 1
Range: 0 to 3
(Set to 3)
Default: 1
Range: 0 to 5
<4>
Default: 0
Range: 0, 1
Default: 1
Range: 0 to 3
Default: 0
Range: 0, 1
Default: 0
<7>
Range: 0, 1
35