Removing The Left Rear Wire Mesh Filter - Thermo Scientific TSQ 9000 Hardware Manual

Thermo Scientific
Figure 80. Removing the Left Rear Wire Mesh Filter
4. Use a T10 Torxhead screwdriver to remove the four screws holding the left rear wire mesh
filter to the left hand sub panel.
5. If you have an optional dust filter, use a T10 Torxhead screwdriver to remove the two
screws holding the filter to the interior front panel.
6. Remove the six screws holding the front wire mesh filter to the frame.
7. Remove the filters.
8. Remove the turbo cooling fan filter cover with a small flat-heat screwdriver.
9. Remove the turbo cooling fan filter.
10. Wash the filters in soap and water.
11. Let the filters dry.
12. Reattach the filters.
13. Replace the turbo cooling fan filter cover.
14. Close the front door of the instrument.
Screws
1
Performing Routine Maintenance
Cleaning the Filters
TSQ 9000 Hardware Manual 95