Thermo Scientific TSQ 9000 Hardware Manual page 416

3
Advanced Troubleshooting
Replacing the Collision Gas Components
388 TSQ 9000 Hardware Manual
22. Pull the tubing out of the manifold. Replace if necessary.
23. Disconnect the collision gas module cable from the distribution board.
Figure 414. Disconnecting the Collision Gas Module Cable from the Distribution Board
24. Disconnect the 1/16 in. tubing from the bulkhead compression fitting located on the left
hand sub panel.
Figure 415. Disconnecting the Cable to the Bulkhead Fitting
Bulkhead
Fitting
25. Use a T20 Torxhead screwdriver to remove the two screws on the collision gas module.
26. Remove the collision gas module and replace if necessary.
Collision Gas Module
Cable Connection
Collision Gas Module
Tubing
Thermo Scientific