Table of Contents
Advertisement
Thermo Scientific
14. Use a T20 Torxhead screwdriver to loosen the two screws holding the support bracket to
the bottom of the instrument.
Figure 409. Removing the Controller Interface Board Support Bracket
15. Remove the controller interface board and PC communication board from the
instrument. The boards are attached together.
16. Disconnect the Ethernet cable from the PC communication board.
Replacing the Collision Gas Components
Controller
Interface Board
Support Bracket
3
Advanced Troubleshooting
TSQ 9000 Hardware Manual
385
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
