Thermo Scientific TSQ 9000 Hardware Manual page 219

Thermo Scientific
Figure 174. Locating Wires on the Source Interface Board
5. Attach a new lens plate and springs to the lens heater block and reattach the screws.
6. Reattach the lens 1, lens 2, and lens 3 wires from the source interface board using a
flat-tipped screwdriver.
7. Once the components are correctly reattached, follow the instructions in
Analyzer Tray in the TSQ 9000 Instrument"
instrument.
8. Restart your system by following the instructions in
3
Advanced Troubleshooting
Replacing Components of the Ion Source
on page 142 to replace the tray in the TSQ
"Restarting the System"
TSQ 9000 Hardware Manual
"Replacing the
on page 145.
191