3
Advanced Troubleshooting
Replacing the Power Supplies
Power Module
358
TSQ 9000 Hardware Manual
To replace the power module
Note See the ISQ and TSQ GC-MS Spare Parts Guide for information about ordering this
component.
1. Shut down your system by following the steps in
on
page
127.
Note You do not have to remove the ion source cartridge or the column or vent the
instrument. If you are using hydrogen as a carrier gas, power off the GC.
2. Slide the top cover panel toward the back of the instrument and lift it off.
3. Disconnect the power cables from the side of the instrument.
"Shutting Down the TSQ 9000 System"
Thermo Scientific