Replacing The Calibrant Reservoir And Cover - Thermo Scientific TSQ 9000 Hardware Manual

Thermo Scientific
5. Attach a new calibrant reservoir to the calibration gas module.
Figure 401. Replacing the Calibrant Reservoir and Cover
Calibrant
Reservoir
6. Fill the calibrant reservoir of the new module by following the instructions in
the Calibrant Reservoir"
7. Reattach the calibrant reservoir cover.
8. Close the front door of the instrument.
9. If you are using hydrogen as a carrier gas, attach the hydrogen safety screws and restart
your GC by following the instructions in
on page 70.
"Restarting the System"
3
Advanced Troubleshooting
Replacing the Calibration Gas Components
Calibrant
Reservoir
Cover
"Refilling
on page 145.
TSQ 9000 Hardware Manual 377