Commissioning Of Floor Stand Incubators; Installing/Removing Air Baffles (Imh-S Series); Figure 5-5 Removing The Bottom Plate; Figure 5-6 Removing The Left And Right Support Profiles - Thermo Scientific Heratherm IMH 60 Operating Instructions Manual

Commissioning of floor stand incubators

Installing/Removing air baffles (IMH-S Series)

The section below describes how to install/remove the bottom plate.
Figure 5-5
1. Loosen and remove the four (4) screws in the bottom plate and then remove the bottom
plate completely.
Figure 5-6
Loosen and remove the eight (8) screws for the left and right support profiles and then take
out the lateral air baffles.
Thermo Scientific
Removing the bottom plate
Removing the left and right support profiles
Installation procedures
Commissioning of floor stand incubators
Heratherm 5-5