3
Advanced Troubleshooting
Replacing the Boards in the TSQ 9000 Instrument
352
TSQ 9000 Hardware Manual
6. Hold the new source interface board next to the old board.
7. As you remove each of the wires from the old board, connect them to the same connectors
on the new board.
Figure 378. Reconnecting the Source Interface Board Wires
8. Once the components are correctly attached to the analyzer tray, follow the instructions
in
"Replacing the Analyzer Tray in the TSQ 9000 Instrument"
tray in the TSQ instrument.
9. Restart your system by following the instructions in
on
page 142
to replace the
"Restarting the System"
on
Thermo Scientific
page
145.