System Command; [Esc+Cs] Print Speed - SATO CL4NX Programming Reference Manual

System Command

Print Speed [ESC+CS]
[ESC+#F] Print Darkness
Print Darkness ( Compatible command) [ESC+#E]
Media Size [ESC+A1]
Base Reference Point [ESC+A3]
[ESC+EP] Print End Position
[ESC+~] Multiple Cut
[ESC+CT] Cut Number Unit
Eject and Cut [ESC+NC]
Cut Number Unit [ESC+~A]
Eject and Cut [ESC+~B]
[ESC+*] Memory Clear
Offline [ESC+@]
Reprint [ESC+C]
[ESC+E] Auto Line Feed
[ESC+PO] Offset
[ESC+IG] Sensor Type
Print Method [ESC+PH]
[ESC+PM] Print mode
[ESC+KM] Mincho (Kanji)
[ESC+KG] Gothic (Kanji)
[ESC+CE] European code page
Forced Tear Off [ESC+TK]
Option Waiting Time [ESC+TW]
Delete CR/LF [ESC+CL]
[ESC+VB] Barcode Checker
Base Reference Point (CL4NX Only) [ESC+#]
Parent topic Part 1 SBPL Commands

[ESC+CS] Print Speed

Hexadecimal code
Initial value
Valid range and term of
command
[Function]
Specifying the speed of printing.
[Format]
<CS>aa
• Parameter
a [Print speed] = Refer to the table below.
[Coding Example]
<A>
<CS>4
<Z>
[Supplementary Explanation]
• Print speed value specified by the command or LCD is maintained.
[Notes]
• If the value over valid range is specified, command error will occur and print speed will not be
changed.
• Use default set operation of the printer to set back the value to the initial one.
• If print mode is linerless cutter, the maximum speed would be 6 inches/sec and initial value
would be 4 inches/sec. Command error does not occur if 7 inches/sec to maximum for each
model has been specified. In that case the value will not be set.
• If print mode is dispenser, the maximum speed would be 10 inches/sec. Command error does
not occur if 11 inches/sec to maximum for each model has been specified. In that case the value
will not be set.
ESC
<1B>
16
Refer to the table below.
When the power is OFF
Valid range within items
Valid range between items
325
CS
<43> <53>
16 16
The set parameter is maintained.
The set parameter is valid until the next valid setting.
The set parameter is valid until the next valid setting.
Parameter
aa