SATO CL4NX Programming Reference Manual page 283

Parameter c
18 91X91
19 95X95
20 101X101
21 105X105
22 109X109
23 113X113
24 117X117
25 121X121
26 125X125
27 131X131
28 135X135
29 139X139
30 143X143
31 147X147
32 151X151
• Aztec code is settable within the range (00H – FFH). For Binary data, user needs to set the data
number properly by using the <ESC>DN command. If Data number and Print data does not
match, symbol will not print properly.
• When print data is [1BH], specify [1BH,1BH]. Data number becomes [0002].
• Use [1BH,*] in pairs within input data when presenting ECI. '*' must be a value between 31H
and 36H. The number in the following FLG(1) - FLG(6) are the number of digits of the data to be
used for ECI.
<ESC>1→FLG(1) The number of digits specified for ECI data is 1 digit.
<ESC>2→FLG(2) The number of digits specified for ECI data is 2 digits.
<ESC>3→FLG(3) The number of digits specified for ECI data is 3 digits.
<ESC>4→FLG(4) The number of digits specified for ECI data is 4 digits.
<ESC>5→FLG(5) The number of digits specified for ECI data is 5 digits.
<ESC>6→FLG(6) The number of digits specified for ECI data is 6 digits.
e.g.)A sample data with <ESC>4 : <ESC>41111ABCDE
The scanned data when <ESC>4 will be "\001111ABCDE" ( '\' may differ depending on scanner
settings).
1) <ESC>4 means FLG(4). The succeeding "1111"(4 digits) will be treated as ECI data.
2) Since it is short by 2 digits, 0 is padded in the beginning to make it "\001111".
• The message ID is enabled only when it is separated to print after automatic setting with
"Number of symbols for structured append" with specifying "Append structured blocks".
Format Digit
1378
1511
1653
1801
1956
2116
2281
2452
2632
2818
3007
3205
3409
3616
3832
281
Text
1104 687
1210 753
1324 824
1442 898
1566 976
1694 1056
1826 1138
1963 1224
2107 1314
2256 1407
2407 1501
2565 1600
2728 1702
2894 1806
3067 1914
Binary data