SATO CL4NX Programming Reference Manual page 494

dmmmm Capital "D" indicates that the
data is in ASCII, lower-case "d"
indicates the data is in HEX.
Specify the length of data in bytes
with the number(mmmm) that
comes after "D" or "d".
n
Data array to write
Parameters from here can be specified in any order.
Parameters related to specifying block to start writing (omissible)
wsb:
Specify block to start writing
Data input format + number of data to write in bytes
Data array to write
The character code and maximum number of characters
depends on the data input/output format (ASCII/HEX) as
below:
ASCII
HEX
492
not change regardless of data format, whether ASCII
or HEX.
Valid range: FeliCa Lite/FeliCa Lite-S(a ＝ 4): "0 ~ 224"
Note:
• Command error occurs if you specify a value that
exceeds the maximum.
Specify 0 if the data of clutch pad is not specified,
and do not specify anything for the next [n:Write Data]
except for a comma only at the end.
Specify 0 if parameters related to NFC(NDEF)
are used, and do not specify anything for the next
[n:Write Data] except for a comma only at the end.
Range of available character codes: (00H) ~
(FFH)
Valid number of characters:
FeliCa Lite/FeliCa Lite-S(a ＝ 4): 0 ~ 224
characters
1 character as a step can be specified.
Range of available character codes:
0(30H) ~ 9(39H),A(41H) ~ F(46H)
Valid number of characters:
FeliCa Lite/FeliCa Lite-S(a ＝ 4): 0 ~ 448
characters
Specify it with the multiples of 2 digits.
Specifies the block to start writing the data. The 0th
block is specified if omitted.
Block is a unit to write to user memory. The following
values in the table are allowed based on the type of
inlets.
A maximum up to a 2-digit decimal can be specified,
but a parameter error occurs if it exceeds the
maximum amount for the specified inlet (14 and
above). See the following table.
Inlet type Capacity
of 1 block
FeliCa Lite 16bytes
FeliCa
Lite-S
Cannot be used together with blt:.
Total Total
number capacity
of blocks
14blocks 224bytes