SATO CL4NX Programming Reference Manual page 125

◦ Alphabet
◦ Number
◦ Hyphen [-]
◦ Underscore [_]
◦ Period [.]
• Character may not be printed correctly if small character size is specified to downloaded TTF
font. Please fully check on print result.
• Print size may be smaller than specified character size with parameter in landscape and portrait
directions due to multi languages.
• If input code is set to UTF-8, the size of character code is available up to 4 bytes. UTF-8 does
not support 5, 6 bytes.
• Formatter functionality and Ligature functionality are used for complex languages (Arabic, Hindi,
Thai) and Hebrew so that proportional is enabled for print regardless of how proportional was
set.
• It is not possible to specify line feed code to in between character codes which forms single
word and single character for complex languages (Arabic, Hindi, Thai) and Hebrew. Rendering
result is not guaranteed if line feed code is specified.
• Please note that it is determined as ESC code if the first byte is 0x1b when UTF-16BE is
specified.
• If the first 2 bytes are specified to range of surrogate pairs (0xD800 to 0xDBFF) when
UTF-16BE is specified, it will be replaced with half size space on the condition that the last 2
bytes are not within the range of surrogate pairs (0xDC00 to 0xDFFF).
• Please note that serialized print may not work properly for languages like Arabic, Hindi, Thai,
and Hebrew because any input character code for those languages are rendered as character
string and this will cause incorrect print position.
• Formatter functionality and Ligature functionality are used for complex languages (Arabic, Hindi,
Thai) and Hebrew so that any input codes are rendered as character string. Input character
codes for other languages than above-mentioned languages are rendered per character so that
character gap is different between complex language and other languages.
• Please note that you may not get character as you expected after it is printed if the combination
of input character code and character set is different from the table below.
[Valid Commands]
Print position <V>
Modification <P>
<H>
<%> <F> <PS>
123
<PR>