SATO CL4NX Programming Reference Manual page 427

• If you specify a value outside the range of parameters, a command error occurs.
• The default factory setting is 100.
• While the same setting can be performed with the [DC2] PA command, this command can
instantaneously change the radio output power without having to restart the printer.
• While a value from 0 to 240 can be recorded in the nonvolatile memory of the printer, the units
place is rounded off to 0 during transmission to the reader/writer module.
• A number that is less than 100 is set to three digits by supplementing with a zero in the high
order digit.
Antenna output power table
Parameter
aaa
0 to 9
10 to 19
20 to 29
30 to 39
40 to 49
50 to 59
60 to 69
70 to 79
80 to 89
90 to 99
100 to 109
110 to 119
120 to 129
Note
• While a value from 0 to 240 can be recorded in the nonvolatile memory of the printer, the units
place is rounded off to 0 during transmission to the reader/writer module.
Example: Even when 199 is specified, actually, 19.0 dBm is set.
Parent topic RFID Command (CL4NX Only)
Antenna output power
(dBm) (mW)
0 1.0
1.0 1.2
2.0 1.5
3.0 1.9
4.0 2.5
5.0 3.1
6.0 3.9
7.0 5.0
8.0 6.3
9.0 7.9
10.0 10.0
11.0 12.5
12.0 15.8
Parameter
aaa
130 to 139
140 to 149
150 to 159
160 to 169
170 to 179
180 to 189
190 to 199
200 to 209
210 to 219
220 to 229
230 to 239
240
425
Antenna output power
(dBm) (mW)
13.0 19.9
14.0 25.1
15.0 31.6
16.0 39.8
17.0 50.1
18.0 63.0
19.0 79.4
20.0 100.0
21.0 125.8
22.0 158.4
23.0 199.5
24.0 250.0