[Esc+Ig] Sensor Type - SATO CL4NX Programming Reference Manual

[ESC+IG] Sensor Type

Hexadecimal code
Initial value
Valid range and term of
command
[Function]
Specifies the sensor type.
[Format]
<IG>a
• Parameter
a [Sensor type]
0 : Reflective (I-mark)
1 : Transmissive (Gap)
2 : Sensor disabled
[Coding Example]
<A>
<IG>1
<Z>
[Supplementary Explanation]
• The setting by this command is normally not needed.
• The set parameter is maintained after turning off the printer.
• Do not use this command while printing operation as sensor may not work properly.
• Receiving print command after changing the sensor type executes printing after backfeed
except specifying the "ignore sensor" to the sensor type. Feed motion is not performed after
turning the printer's power off and then power on.
• Command error occurs when setting printer operation mode to [Tear-Off] and [Dispenser] and
specifying sensor type to 2 (Ignore sensor).
• When printer operation mode is set to [Linerless cutter], the range will be available only in
0: Reflective sensor (I-MARK) and 2: Ignore sensor. When 1: Transmissive sensor (GAP) is
specified, there will be no command error. In this case, no value will be set.
Parent topic System Command
ESC
<1B>
16
a=1
When the power is OFF
Valid range within items
Valid range between items
353
IG
<49> <47>
16 16
The set parameter is maintained.
The set parameter is valid until the next valid setting.
The set parameter is valid until the next valid setting.
Parameter
a