[Esc+/A] Air Protocols Management (Cl4Nx Only) - SATO CL4NX Programming Reference Manual

[ESC+/A] Air Protocols Management (CL4NX Only)

Hexadecimal code
Initial value
Valid range and term of
command
[Function]
To set the type of Air Protocols to be used and get the information about supported Air Protocols.
[Format]
</A>,a,b
• Parameter
a [Air Protocol management]
0 : Get a list of all the supported Air Protocols
1 : Get the type of Air Protocol which is in use
2 : Set the type of Air Protocol to be used
b [RFID options to be used]
0 : set "EPC Class 0+"
1 : set "EPC Class 1"
2 : set "GEN 2" (Supported in CL4NX printer only)
3 : set "EPC Class 1.19(UCODE)"
This parameter b is needed when a = 2 was specified.
[Coding Example]
Get the type of Air Protocol which is in used.
<A>
</A>,1
<Z>
Set the type of Air Protocol to "EPC Class 1".
<A>
</A>,2,1
<Z>
[Supplementary Explanation]
• To avoid incorrect response from printer, this command should not use in conjunction with other
commands.
• Parameter 'a' will be set as '0' if not assigned.
• Air Protocol setting by "</A>,2,b" is maintained until next change is made in LCD panel or "</
A>,2,b" command again.
• For (a=2), the command will become invalid if the parameter 'b' is not assigned or wrong
reference number is assigned. (Note: Depending on the RFID modules, the command will
become invalid if user set the RFID option that is not supported by module.)
ESC /A
<1B> <2F>
16
a = 0
When the power is OFF
Valid range within items
Valid range between items
Parameter
< 41> ,a,b
16 16
The set parameter is maintained.
The set parameter becomes invalid.
The set parameter becomes invalid.
518