[Supplementary Explanation]
•
The inter-character pitch of the barcode is valid at CODABAR (NW-7), CODE39, Industrial 2of5
and Matrix 2of5.
The barcode inter-character pitch is set by specifying the character pitch <P> immediately
before.
If not set, the inter-character pitch will be of the same size as a narrow space and will become
multiples of a narrow bar.
e.g.)
Command
<D>
•
For print data of each barcode type, refer to the code tables of barcode.
[Notes]
•
If the value other than valid range is set, command error will occur and barcode will not be
printed.
•
Barcode will be printed even if the data exceed the printing area.
•
Increasing narrow bar width may exceed the printing area.
•
Scanner may not read the barcode with valid character pitch when Character Pitch <P> is
increased. Also, increasing the narrow bar width may cause the same type of problem. For
more information, refer to the documentation of your scanner.
•
For specifying the narrow bar width, consider the reading compatibility of scanner and head
density beforehand.
◦
203 dpi: 2 dots or more
◦
305 dpi: 2 dots or more
◦
609 dpi: 4 dots or more
•
Adjust Print Speed <CS> or Print Darkness <#F> if there is a problem in barcode reading.
•
Matrix 2of5 will be expressed as Coop2of5/NEC2of5.
•
If Start/Stop character is not included in print data at the time of CODABAR (NW-7) or CODE39
specified, barcode will be printed; however, scanner cannot read it.
•
If sending the print data including check digit at the time of JAN/EAN-13 or JAN/EAN-8
specified, set the correct calculated value. Barcode will be printed even when the data includes
improper check digit; however, scanner cannot read it.
Parent topic
Barcode Command
Ratio
Narrow
space width
1:2
1
<P>
specification
None
1
<P>0
1
<P>1
1
<P>2
2
<P>3
3
<P>4
4
186
Gap between characters
Narrow bar
Narrow bar
width is [1]
width is [2]
2
2
2
4
6
8