System Mode - SATO Argox D4-250 User Manual

1 Introduction

1.4.2 System mode

The system mode consists of status light color combinations. It contains a
list of commands for you to select and run.
To enter the system mode and run the command, do the following:
1. Turn off the printer.
2. Press and hold the FEED button, and turn on the printer.
3. Both status lights glow solid amber for a few seconds. Next, they turn to
green shortly, and then turn to other colors.
4. When status lights show the color combination you need, release the
FEED button immediately.
5. Press the FEED button to run the command.
The following table is the command list of the system mode.
LED 2
Red
Amber
Red
Amber
Green
Red
Green
LED 1 Command
Green Transmissive Sensor Calibration
Green Reflective Sensor Calibration
Red Resetting Your Printer
Red Reserved
Red Disable Checking RTC Battery Charge
Amber Reserved
Amber Self Test
9
(Section
(Section 3.2)
(Section 3.1)
(Section 3.1)
3.3)