SATO CL4NX Programming Reference Manual page 583

[Supplemental explanation]
• This command cannot be used in combination with commands other than <A> and <Z>.
• Available with the following printer operation modes:
continuous, cutter (backfeed after print), and dispenser (backfeed after print).
Not available with tear-off, cutter (backfeed before print), dispenser (backfeed before print).
• Not available with RFID tag offset is set to a non-default value.
• Because this command cannot be received while printing it, information cannot be acquired in
"Sequential number" and "Print Quantity" piece is specified.
• After this command is transmitted, it will take about five seconds by the time all the sending
return status is sent back by the host. Tag information is not correctly sent back when the port
is cut before all the sending return status is sent back by the host, data other than the sending
return status format are sent back, and operate it, please after selecting data.
• Please do not transmit other commands and data until all the status of the defined size is
received by the host after transmitting this command.
• Refer to the following chart if you want to specify the alphabet "A" in ASCII/HEX data formats.
Data
Code
• If the printer is a low power consumption mode is enabled, until it wakes up will return a "NAK".
[Sequence]
Host
Parent topic Common commands for all languages
Mode
'A'
41H
D C 2 + PJ,aa(,aa),bb
STX + aa,bb, + cc:d...d,e...e + ETX
Or, STX + aa,bb, + cc:e...e + ETX
ASCII
This product
581
HEX
"41"
34H,31H