[Esc+$=] Outline Font Print - SATO CL4NX Programming Reference Manual

[ESC+$=] Outline Font Print

Hexadecimal code
Initial value
Valid range and term of
command
[Function]
Specifying printing command of outline font.
[Format]
< $＝ >n...n
• Parameter
n [Print data] = Data
[Coding example]
Print data: SATO
<A>
<V>100<H>100<P>2
<$>A,100,100,1<$=>SATO
<Q>2
<Z>
[Supplementary Explanation]
• The outline font printing command <$=> shall be executed after the outline font design selection
<$>.
• Font height includes both ascender and descender area. For proportional pitch, the character
width of outline font differs depending on the font to be used.
• Use character pitch command <P> to specify font pitch.
• Italic characters are tilt in an angle of 15-degree, within their specified width. As for the height
specification, both ascender and descender area are included.
• For the font design 1 through 9, if the specified dot setting is irregularly small, the font cannot be
identified.
• If the font width / height are very small, there can be cases that the font is squeezed.
• JIS, Shift JIS, or Unicode (UTF-16, UTF-8) can be used for Kanji outline font, which should
correspond with the printer settings to proper printing. Specify Kanji code by <KC> command or
LCD setting.
ESC
<1B>
16
Nil
When the power is OFF
Valid range within items
Valid range between items
107
$=
<24> <3D>
16 16
The set parameter is not maintained.
The set parameter becomes invalid.
The set parameter becomes invalid.
Parameter
n...n