SATO CL4NX Programming Reference Manual page 312

[Supplementary Explanation]
• Size of MaxiCode are not changed by number of data for printing.
• If parameter that is not described above is used, or number of print data does not match,
symbol is not printed.
• When specifying mode 4 and mode 6, number of print data must be specified over 12. When
number of print data is specified less than 11, scanner cannot read printed MaxiCode.
[Precautions during use]
• This is the command of the old specification. Recommend the use of <2D20>.
MaxiCode Code table
MaxiCode can specify from 1H to FFH.
Parent topic 2D Code
310