SATO CL4NX Programming Reference Manual page 731

*4 When SW15 on IF board is set to 2-3, the no.9 pin operates as offline output. When set to 1-2 side, the
printer operates as input (Set to 2-3 as shipment settings).
*5 Output pin No. can be set for Waiting for dispenser completion and label near end from Exit Signals from
settings on GUI. Default: "Unspecified".
*6 Output timing of print end signal (PREND) is changed when Wait signal for dispenser is set to valid. Please
refer to "3) Output waiting for dispenser" in next section of "I/O signal" for details.
[Notes]
• External signal may become unstable for around 1 second after power on. Please control after 1
second.
• Signal level changes when the conditions in the "Contents" column are met.
e.g. 1) For Pin no.1, signal level becomes Low when Paper End occurs. Then the switch is
turned on and the current flows.
e.g. 2) The print start signal for pin no.5 is when the signal is set to Low level and current flows.
[Supplementary Explanation]
• The mapping of pin no. and signal name (contents) can be changed via Interface > External I/O
menu.
Parent topic External signal interface
729