SATO CL4NX Programming Reference Manual page 556

[Sensor information data list]
No. Sensor information name
1 IM
2 GAP
3 HEAD OPEN
4 CUTTER OPEN
5 DISPENSER
6 HEAD TEMP
7 RIBBON
8 SENSOR HIGH
9 SENSOR LOW
[Note]
• When sending this command in continuation, be sure to set a fixed interval (100 msec or more).
• If the sensor information acquisition processing for each sensor does not finish within 100 msec,
a timeout is thought to have occurred, and [NAK] is returned. A timeout may occur during the
printer operation.
• SENSOR HIGH, SENSOR LOW is the value of the last label that passed through the sensor.
Therefore it may sometimes be different from test printing results (the value is measured with
the label before printing).
• If the sensor type is set to NONE, the SENSOR HIGH and SENSOR LOW values return as 0.0.
Host
Parent topic Common commands for all languages
I-Mark sensor
Gap sensor
Head Open
Cutter open
Dispense sensor
Head thermistor
Ribbon slit sensor
High value of active sensors
Low value of active sensors
DC2 + PD
STX + a...a,b...b:c...c,(d...d:e...e) ... + ETX
Description
This product
554
Sensor information data
X.X/SLY.Y
X.X = 0.0 to 3.3 : Sensor level
Y.Y = 0.0 to 3.3 : Slice level
X.X/SLY.Y
X.X = 0.0 to 3.3 : Sensor level
Y.Y = 0.0 to 3.3 : Slice level
0: Close, 1: Open
0: Close, 1: Open
0: Without label, 1: With label
-XX to XX: Thermistor
temperature
0: Slit ON, 1: Slit OFF
X.X = 0.0 to 3.3 : Sensor level
X.X = 0.0 to 3.3 : Sensor level