SATO CL4NX Programming Reference Manual page 226

[Supplementary Explanation]
• This command supports UPC-A only. When barcode type is specified other than "H", command
error occurs.
• HRI needs following conditions;
203 dpi (8 dots /mm) : Set Narrow bar width to [02] or [03]
305 dpi (12 dots/mm) : Set Narrow bar width to [03] or [04]
609 dpi (24 dots/mm) : Set Narrow bar width to [06] or [07] or [08]
When the value other than above are specified, HRI is not printed.
• Setting of Guard bar, HRI and Ratio is following.
Guard bar : Available
HRI : Available
Ratio : Fix
• When the parameter value exceeds the range, operation is not supported.
• All character barcode have the same height when printing UPC-A specifying <BD> and then
<font>. The first and the last character barcode have the same height to the guard bar when
printing UPC-A specifying <BM> and then <font>. When printing UPC-A specifying <BD> and
<font>, HRI can be printed under the first digit and the last digit because the height of the
first digit and the last digit of the barcode is low. When printing UPC-A specifying <BM> and
<font>, the height of the first digit and the last digit of the barcode is high, and the font interval is
narrower than previous case.
UPC-A specifying <BD>
UPC-A specifying <BM>
Parent topic Barcode Command
224